Chery A1 2009 Service Manual page 241

10.
CHECK CAMSHAFT
• Check the following:
− Accumulation of debris on the signal plate at the rear of the camshaft.
− Chipped signal plate teeth at the rear of the camshaft.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Remove any debris and clean the signal plate at the rear of the camshaft or replace camshaft.
11.
CHECK DTC
• With the X-431 scan tool, read ECM DTCs.
• Refer to DTC Confirmation Procedure .
Is DTC P0343 still present?
Yes >>
Replace the ECM.
NOTE : The Immobilizer control module must be matched to the new ECM (See ECM Removal & Instal-
lation in Section 03 Electronic Engine Controls).
No >>
The system is now operating properly.
Reassemble the vehicle and road test to verify the customers complaint is repaired.
134
03–
DIAGNOSIS & TESTING
Chery Automobile Co., Ltd.