Measurement Computing miniLAB 1008 User Manual page 63

miniLAB 1008 User's Guide
The
o
next row is automatically highlighted for the next signal test.
If the
o
following dialog displays.
Click on the
the connection and the test still fails, contact MCC Technical Support.
3. Repeat the test in each row until all of the signals have been tested. The wire
illustration dynamically updates the numbers of the pins that you connect in each
row. The dialog below shows the
digital signal tests.
4. When you are done testing the digital channels, click on the
InstaCal's main form.
status light illuminates green to indicate a successful test, and the
Pass
status LED turns red, the test on the connection failed, and the
Fail
button, check your connections, and repeat the test. If you verify
OK
Calibrating and Testing the Device
dialog after you pass all of the
External DIO Test
5-5
button to return to
OK