Instacal; Tracerdaq - Measurement Computing miniLAB 1008 User Manual

Usb device for analog and digital i/o

Hide thumbs Also See for miniLAB 1008:

Table of Contents

miniLAB 1008 User's Guide

InstaCal

InstaCal is a complete installation, calibration, and test program for MCC data

acquisition and control hardware. Complete with extensive error checking, InstaCal

guides you through the installation and setup of your miniLAB 1008, and creates the

hardware configuration file for use by your programming or application software.

InstaCal provides the easiest way to calibrate and configure the miniLAB 1008.

are plotted as they are acquired. Once acquired, you can save the measurement data to a

text or Excel file, and capture the graphical display as a bitmap. TracerDAQ online help

includes a quick start exercise that explains how to acquire and display data. You can

launch TracerDAQ from InstaCal's

In the example below, the TracerDAQ virtual strip chart displays data acquired from two

channels on the miniLAB 1008.

TracerDAQ is installed with InstaCal. TracerDAQ includes fully-

configured and ready-to-run virtual instruments, such as a strip chart

and oscilloscope. You can use these instruments to plot data from

the miniLAB 1008 directly to your computer. Your measurements

Applications

1-3

Introducing the miniLAB 1008

menu.

Table of Contents

Do you have a question about the miniLAB 1008 and is the answer not in the manual?