Setting Up The Minilab 1008 With Instacal; Adding The Minilab 1008 To The Instacal Configuration File - Measurement Computing miniLAB 1008 User Manual

miniLAB 1008 User's Guide
To install SoftWIRE MCC DAQ Components or SoftWIRE MCC DAQ Controls,
follow the procedure below.
1. Click on the
A
SoftWIRE DAQ Components Installation
2. Click to select either
MCC DAQ Controls for VB6
3. Follow the installation instructions as prompted.

Setting up the miniLAB 1008 with InstaCal

Use InstaCal to configure the number of analog input channels (eight single-ended or
four differential) on the miniLAB 1008, and also to change the custom serial number.

Adding the miniLAB 1008 to the InstaCal configuration file

To run InstaCal and add the miniLAB 1008 to its configuration file, follow these steps.
1. Click on
A
Plug and Play Board Detection
The
Plug and Play Board Detection
opens when you first install or if you reinstall the miniLAB 1008.
SoftWIRE DAQ Components
SoftWIRE MCC DAQ Components for VS .NET
Start > Measurement Computing > InstaCal
button.
dialog opens.
, and click on the
Install
dialog opens in front of the
dialog lists the miniLAB 1008, and only
2-9
Installing the miniLAB 1008
, or
button.
to launch InstaCal.
main form.
InstaCal
SoftWIRE