Configuring The Minilab 1008 With Instacal - Measurement Computing miniLAB 1008 User Manual

miniLAB 1008 User's Guide

Configuring the miniLAB 1008 with InstaCal

To change the configuration of the miniLAB 1008, follow the steps below.
1. Double-click on the miniLAB 1008 item listed below
The
Board Configuration
Pull down the
Ended as the analog input configuration.
Pull down the
use as the trigger source.
To change the custom serial number assigned by InstaCal to the miniLAB 1008 —
as part of a numbering scheme to keep track of multiple units in the field, for
example — enter a number from 1 to 255 in the
miniLAB 1008 stores its serial number in its memory, and retains the serial number
even when it is powered down.
If you installed more than one miniLAB 1008, you can click the
to identify the miniLAB 1008 device that you are configuring. Clicking on this
button causes the LED of the selected miniLAB 1008 to blink.
2. Click on the
3. When you are done using InstaCal, select
dialog opens.
No. of Channels:
list box and select the digital bit (DIO0 to DIO4) to
Trigger Source:
button to close the dialog.
OK
list box and select either 4 Differential or 8 Single
Custom Serial No:
from the
Exit
2-11
Installing the miniLAB 1008
Universal Serial Bus
text box. The
Flash LED
menu to close InstaCal.
File
.
button