Table 27: Sfp Network Port Connector Pinout Information - Juniper EX2200 Hardware Manual

Table 26: 10/100/1000BASE-T Ethernet Network Port and 100/1000/2500/5000/10000BASE-T Ethernet
Network Port Connector Pinout Information for EX4300-48MP and EX4300-48MP-S Switches (continued)
Pin Signal
8 TRP4-

Table 27: SFP Network Port Connector Pinout Information

Pin Signal
1 VeeT
2 TX_Fault
3 TX_Disable
4 SDA
5 SCL-
6 MOD_ABS
7 RS
8 RX_LOS
9 VeeR
10 VeeR
11 VeeR
Copyright © 2018, Juniper Networks, Inc.
Description
Transmit/receive data pair 4
Negative Vport 2
NOTE:
The Ethernet cables that you use to connect to the RJ-45 network ports on
EX4300-48MP and EX4300-48MP-S switches and provide 95 W power over
4 pair wire must meet the following specifications related to deployment,
temperature rise, category, IEEE, UL, NEC, and local electric codes to ensure
proper performance and to not exceed rated temperature and ampacity of
cables:
The cables must be shielded RJ-45 cables.
The cables must be rated for IEEE 802.3 BT, TIA standards, and UL-LP.
The cables must follow NEC 725.144 article and local electric code.
The operating temperature of the cable must be rated at 15° C more than
the ambient temperature.
Description
Module transmitter ground
Module transmitter fault
Transmitter disabled
2-wire serial interface data line
2-wire serial interface clock
Module absent
Rate select
Receiver loss of signal indication
Module receiver ground
Module receiver ground
Module receiver ground
Chapter 2: Site Planning, Preparation, and Specifications
61