Maintaining Fiber-Optic Cables; Connecting A Fiber-Optic Cable; Figure 59: Installing A Transceiver - Juniper EX2200 Hardware Manual

EX2200 and EX2200-C Switches Hardware Guide

Maintaining Fiber-Optic Cables

Connecting a Fiber-Optic Cable

146

Figure 59: Installing a Transceiver

1— Ejector lever
Connecting a Fiber-Optic Cable on page 146
Disconnecting a Fiber-Optic Cable on page 147
Maintaining Fiber-Optic Cables on page 148
Before you begin to connect a fiber-optic cable to an optical transceiver installed in a
device, ensure that you have taken the necessary precautions for safe handling of lasers
(see "Laser and LED Safety Guidelines and Warnings" on page
To connect a fiber-optic cable to an optical transceiver installed in a device:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
188).
Figure 55 on page 110).
Copyright © 2018, Juniper Networks, Inc.