SMA SUNNY ISLAND 4.4M Operating Manual page 166

14 Troubleshooting
Event number Message, cause and corrective measures
10340 Webconnect disabled
The Webconnect function has been switched off. This means that the inverter can not commu-
nicate with Sunny Portal without an additional SMA communications product (e.g.
Sunny Home Manager).
10414 Shutdown due to fault
10415 Automatic start
10416 Manual start (change-over from standby to op)
10417 Manual stop (change-over from op to standby)
10418 Ext. start via system control (chg-over from op to standby)
10419 Ext. stop via system control (chg-over from op to standby)
10420 Self-consumption control was started
The battery is automatically charged or discharged depending on the purchased electricity
or the grid feed-in.
10421
Self-consumption control was stopped
The automatic charging or discharging of the battery stopped due to an external control
command.
10422 Only charging operation in self-consumption mode
The battery is charged only when increased self-consumption is active. The battery is only
charged again once there is sufficient PV power in the system.
10423 Full or equalization charge with active increased self-consumption
10424 Switch back to increased self-consumption after completion of full or equalization
charge
10425 The device switches off
10426 Multifunction relay [xx] of device at Lxx is [xx]
10427 Transfer relay [xx] of device at Lxx is [xx]
10428 Event [xx] of process interface
10429 Message from process interface: [xx]
10517 Dynamic active power limitation started.
The inverter limits the active power of the PV inverters to the set limit.
10518
Dynamic active power limitation terminated.
The inverter terminated the active power limitation of the PV inverters.
166 SI44M-80H-13-BE-en-15
• If the inverter is to communicate with Sunny Portal without an additional SMA
communication product, switch the Webconnect function on.
SMA Solar Technology AG
Operating manual