Toshiba e-STUDIO556 Service Manual page 88

[EB30] Ready period time-out jam
Is there paper in the equipment?
NO 

YES
Are the IPC board and LGC board properly connected to each other?
NO 

YES
Is the harness securely connected to the IPC board?
NO 

YES
Is any of the connector pins of the harness connecting the equipment and finisher
disconnected or any of those harnesses open circuited?
NO 

YES
1. Replace the IPC board.
2. Replace the LGC board.
3. Replace the finisher controller PC board.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Replace the LGC board.
Connect them properly.
Connect the harness properly.
Connect the pin or replace the harness.
8 - 87
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8