Toshiba e-STUDIO556 Service Manual page 81

Hide thumbs Also See for e-STUDIO556:

[EAA0] Power-ON Jam

Is there any paper remaining on the transport path in the finisher or saddle stitcher section?

Is any of the connectors J10, J13 and J9 on the saddle stitcher controller PC board

disconnected?

Is the harness connecting the saddle stitcher controller PC board and No.1 paper sensor

(PI18S) open-circuited?

Is the harness connecting the saddle stitcher controller PC board and No.2 paper sensor

(PI19S) open-circuited?

Is the harness connecting the saddle stitcher controller PC board and No.3 paper sensor

(PI20S) open-circuited?

Is the harness connecting the saddle stitcher controller PC board and vertical path paper

sensor (PI17S) open-circuited?

Is the harness connecting the saddle stitcher controller PC board and delivery sensor

(PI11S) open-circuited?

Is the No.1 paper sensor working properly? (Check the movement of the actuator.)

Is the No.2 paper sensor working properly? (Check the movement of the actuator.)

Is the No.3 paper sensor working properly? (Check the movement of the actuator.)

Is the vertical path paper sensor working properly? (Check the movement of the actuator.)

Is the delivery sensor working properly? (Check the movement of the actuator.)

Replace the saddle stitcher controller PC board.

e-STUDIO556/656/756/856/557/657/757/857

ERROR CODE AND TROUBLESHOOTING

Remove the paper.

Connect the connectors securely. Replace the harnesses.

1. Connect the connectors of the sensors securely.

2. Attach the actuators securely if their shafts are out of place.

3. Replace the sensors.

Show Quick Links