Toshiba e-STUDIO556 Service Manual page 648

05/08 Mode Element Sub
element
08 Setting Counter Paper
Mode feeding
08 Setting Counter Paper
Mode feeding
08 Setting Counter Paper
Mode feeding
08 Setting Counter Counter
Mode
08 Setting Counter Paper
Mode feeding
e-STUDIO557/657/757/857
Item Subitem Code Sub-
6240
6241
6242
6244
6245
Details Default Acceptable
code value value
Feeding retry counter 0 8 digits
upper limit
value(Bypass feed)
Feeding retry counter 0 8 digits
upper limit
value(Tandem LCF)
Feeding retry 0 8 digits
counter(Option LCF)
Counter for tab paper 0 8 digits
Feeding retry counter 0 8 digits
upper limit value (O-
LCF)
79
RAM Contents
M When the number of feeding retry (08-6230 to 08-6235)
exceeds the setting value, the feeding retry will not be
performed subsequently. In case "0" is set as a setting
value, however, the feeding retry continues regardless
of the counter setting value.
M When the number of feeding retry (08-6230 to 08-6235)
exceeds the setting value, the feeding retry will not be
performed subsequently. In case "0" is set as a setting
value, however, the feeding retry continues regardless
of the counter setting value.
M Counts the number of times of the feeding retry from
the Option LCF.
M The counter starts counting up when the registration
sensor is turned ON in the Tab Paper mode.
M When the number of feeding retry (08-6242) exceeds
the setting value, the feeding retry will not be performed
subsequently. In case "0" is set as a setting value,
however, the feeding retry continues regardless of the
counter setting value.
* In this equipment, a toner image is formed on the
transfer belt prior to a paper feeding. When the feeding
retry occurs and the transport timing is delayed, the
toner image on the transfer belt is cleaned off without
the 2nd transfer since the paper cannot be reached for
the 2nd transfer process. After that, the toner image
formation is retried while the paper is waited. In this
case, the toner for this image formation is consumed
wastefully since the toner image on the transfer belt is
already cleaned off, even though the printing is
normally completed. Therefore, note that the excessive
toner will be consumed consequently when the upper
limit value of feeding retry counter is set larger or set as
"0" (no limit). The toner is also consumed wastefully
when the paper misfeeding occurs. Replace the roller
at earlier timing if the paper misfeedings have occurred
frequently.
Proce Servic
dure e UI
1
1
1
1
1