Toshiba e-STUDIO556 Service Manual page 448

Sub
05/08 Mode Element
element
08 Setting System General
Mode
08 Setting System Initialization
Mode
08 Setting System User interface External counter
Mode
08 Setting System Maintenance General
Mode
08 Setting System User interface Screen setting
Mode
08 Setting System
Mode
08 Setting System
Mode
08 Setting System HDD
Mode
08 Setting System General
Mode
e-STUDIO556/656/756/856
Item Subitem Code
9027
9030
9037
9050
9051
9060
9060
9072
9081
Sub- Default Acceptable
Details
code value value
Forcible end of trial -
period
Initialization after -
software version up
Job handling-short 1 0~1
paid-coin controller
Performing panel -
calibration
Panel calibration 0 0~1
setting value
Destination display at Refer to 0-255
SRAM initialization contents
Destination display at Refer to 0-255
SRAM initialization contents
Performing HDD -
testing
Initialization of -
department
management
information
105
RAM Contents
SYS [CANCEL]: Cancel
[EXECUTION]: Forcible end
When the "Forcible end of trial period" is performed, "0"
is set in the code (08-9023) to end up the trial period
forcibly.
- Perform this code when the software in this equipment
has been upgraded.
SYS Sets whether pause or stop the printing job when it is
short paid using a coin controller. 0: Pause the job 1:
Stop the job
SYS Performs the calibration of the pressing position on the
touch panel (LCD screen). The calibration is performed
by pressing 4 reference positions after this code is
started up.
SYS Switches whether the screen for displaying panel
calibration setting values is displayed or not.0: Disabled
(screen not displayed) 1: Enabled (screen displayed)
SYS 0: MJD 1: NAD 2: JPD 3: AUD 4: CND 5: KRD 6:
TWD 7: SAD 8: ASU 9: ASD 10: ARD
<Default value>
MJD: 0 NAD: 1 JPD: 2 AUD: 3 CND: 4 TWD: 6
SAD: 7 ASD: 9 ARD: 10
SYS 0: MJD 1: NAD 2: JPD 3: AUD 4: CND 5: Not used
6: TWD 7: Not used 8: Not used 9: ASD 10: ARD
<Default value>
MJD: 0 NAD: 1 JPD: 2 AUD: 3 CND: 4 TWD: 6
ASD: 9 ARD: 10
SYS Checks the bad sector. It may take more than 30
minutes to finish the checking.
SYS Initializing of the department management information
* Key in the code and press the [INITIALIZE] button to
perform the initialization. If the area storing the
department
management information is destroyed for some reason,
"Enter Department Code" is displayed on the control
panel even if the department management function is
not set on. In this case, initialize the area with this code.
This area is normally initialized at the factory.
Proce Servic
dure e UI
3 Yes
3 Yes
1 Yes
1 Yes
1 Yes
2
2
3 Yes
3