Placement And Securing The Main System Frame; Component Mounting - Sea Recovery SRC Aqua Matic 450-1 Owner's Manual

14. SPECIFIC TO Aqua Matic COMPACT STYLE SYSTEM pages 33 - 42:
A. PLACEMENT AND SECURING THE MAIN SYSTEM FRAME:
The System Frame must be placed
in a location that allows access for
operation and maintenance. Allow
sufficient room for filter bowl
removal. Allow access to the right
side of the frame for electrical wire
attachment. Ensure that the
Touch Pad is reachable and
readable.
The System Frame is mounted in
place with 4 supplied rubber
isolation mounts. 4 Threaded bolts
and 4 sheet metal screws are
provided for attachment. Set the
System in place onto a flat surface
and mark the mounting holes.
Move the System Frame out
of the way and drill the
appropriate hole depending on
which hardware will be
used, bolts or screws. Place the System Frame over the drilled holes and attach the rubber isolation grommet
under the frame at each of the 4 mounting holes. Place the mating rubber isolation grommet over the top of the
frame hole and attach with the appropriate supplied washers, and bolts or screws.
B. COMPONENT MOUNTING:
All mounting surfaces must be flat in order to avoid warping of brackets and frames. Any damage caused by
attaching the system or its components to an uneven surface is attributed to improper installation, is the liability
of the installer, and is not covered by the Sea Recovery warranty. Grind flat or use appropriate shims on uneven
surfaces to ensure that mounting of the system components does not cause bending or warping.
Do not connect the water lines or electrical lines to the various components until each of the components are in
place and secure. After all components are in place and secure visually inspect the layout to ensure that the
plumbing hoses and tubes will connect kink free, in short and straight segments, and will avoid heat and
abrasions from surrounding surfaces.
1. Attach the supplied Inlet Connection [3] to the Sea Cock Valve and rotate it towards the
location of the Sea Strainer [4] Inlet.
2. Allow sufficient space between the Inlet Connection [3] and Sea Strainer [5] for the Inline
Vacuum/Pressure Gauge [4], if used.
Allow Space
in Front of System
for Access to
Touch Screen for Operation.
Allow Space
Under Prefilter
Secure to Solid Flat Base
For Filter Element
Changing
section 2 page 27 of 56
Aqua Matic 450-1800 Rev. A
Allow Space
to the side of Frame
for R.O. Membrane Element Removal
or Above Frame for
Vessel Removal from Frame
Allow Space around System to access
the Internal Components for Msaintenance
Allow Space
Under Post Filter
For Filter Element Changing
Inlet
Connection
Inline Vacuum /
Pressure Gauge