Sea Recovery SRC Aqua Matic 450-1 Owner's Manual page 100

Aqua Matic 450-1800 Rev. A
B. Programming the Aqua Matic computer logic:
1. SCREEN CONTRAST
Changes the viewing angle of the Touch Pad for easy viewing
1 Screen 2
st
007
Touch the Logo Touch MENU
2. U.S. STANDARD MEASUREMENTS OR METRIC STANDARDS MEASUREMENTS SCREEN 438
Toggles the measurement standards between U.S. Standards and Metric Standards
Pressure: U.S. Standard = PSI (Pounds Per square Inch); Metric Standard = kPa (kilo Pasquel)
Flow: U.S. Standard = GPM (Gallons Per Minute) or GPH (Gallons Per Hour); Metric Standard =
LPM (Liters Per Minute) or LPH (Liters Per Hour).
1 Screen 2
st
007
Touch the Logo Touch MENU
3. DIVERSION VALVE SET POINT
Sets the Aqua Matic control logic to energize the 3-Way Product Water Diversion Valve [41] at a specific
product water quality, in PPM (Parts Per Million). The factory setting is 800 PPM TDS (eight hundred
Parts Per Million Total Dissolved Solids expressed as NaCl [sodium chloride - salt]).
1 Screen 2
st
007
Touch the Logo Touch MENU
Screen 3 Screen
nd rd
044
Touch CONTRAST
Screen 3
nd rd
044
Touch US STD to revert to METRIC
Touch METRIC STD to revert to US
Touch RETURN to confirm
Screen 3 Screen
nd rd
044
Touch SERVICE
MENU
section 3 page 4 of 12
4 Screen
th
008
Touch & Move the BAR up or down
Touch SAVE to save the change
or
Touch CANCEL to revert to original
setting.
Screen
008
4 Screen
th
008
Touch DV SET
POINT
107
5 Screen
th
042 018
Touch the BAR & move
it to the desired setting.
Touch OK to confirm
the new setting.
or
Touch CANCEL to
revert to original
setting.