Sea Recovery SRC Aqua Matic 450-1 Owner's Manual page 219

An Aqua Matic High Pressure Pump requiring maintenance within the warranty period, and if after
examination by Sea Recovery is found to be non-operational due to a warranty failure, will be repaired
or replaced with a rebuilt pump at Sea Recovery's option.
An Aqua Matic High Pressure Pump requiring maintenance that is not within the warranty period, or
is damaged due to non warranty reasons, will be repaired or replaced with a rebuilt pump depending on
the severity of damage.
For repair or replacement, contact Sea Recovery for a Material Return Authorization and shipping
instructions.
26. High Pressure Hose [26]:
The High Pressure Hose has been assembled with crimp fittings by Sea Recovery. The High Pressure Hose is
NOT repairable. Should a leak, damage, or failure develop order a replacement hose from Sea Recovery.
27 & 28. Reverse Osmosis Membrane and Pressure Vessel Assembly [27 & 28]:
NOTES:
The Aqua Matic Membrane Element is accessible with the Vessel still attached to the frame, provided
o
there is sufficient room to the left and right of the System to remove the R.O. Membrane Element.
Replace all Brine and Product Water O-Rings attached to the End Plugs within the High Pressure
o
Vessel Assembly each time the Reverse Osmosis Membrane Element is removed or replaced. Ensure
these O-Rings are on hand prior to repair.
R.O. Membrane Elements are only installed and removed from the INLET end of the High Pressure
o
Vessel.
section 8 page 17 of 30
Aqua Matic 450-1800 Rev. A