Sea Recovery SRC Aqua Matic 450-1 Owner's Manual page 329

Two similar pumps are commercially available. One has a lower water flow rate, the other has a
higher water flow rate than the Sea Recovery High Pressure Pump.
The commercially available lower water flow rated pump will cause:
a. Poor quality Product Water.
b. Low Product Water Flow.
b. Excessive operating pressure as the System attempts to adjust pressure to achieve rated
Product Water Flow.
b. Immediate fouling of the Sea Recovery Aqua Matic R.O. Membrane Elements resulting in
unrecoverable damage to them.
The commercially available higher water flow rated pump will cause:
a. Low feed water pressure into the high pressure pump.
b. Line pressure loss of feed water resulting in continual system shut down.
c. Cavitation to the high pressure pump resulting in premature failure of the pump.
d. Extensive Line Pressure Build-Up in the High Pressure Hoses and Manifolds.
d. Telescoping damage of the R.O. Membrane Elements due to excessive feed flow across
them.
e. Over heating of the High Pressure Pump Electric Motor due to excessive load.
NEVER REPLACE THE SEA RECOVERY HIGH PRESSURE PUMP WITH A THIRD PARTY, NON
SEA RECOVERY SUPPLIED, HIGH PRESSURE PUMP. THE SEA RECOVERY AQUA MATIC
HIGH PRESSURE PUMP IS NOT AVAILABLE THROUGH ANY SOURCE OTHER THAN SEA
RECOVERYand SEA RECOVERY DEALERS. WHEN REPAIRING OR REPLACING THE HIGH
PRESSURE PUMP ENSURE THAT THE MARINE DEALER HAS OBTAINED THE REPAIR
PARTS OR THE PUMP FROM SEA RECOVERY.
DAMAGE CAUSED TO THE SEA RECOVERY SYSTEM RESULTING FROM THE USE OF NON
SUPPLIED SEA RECOVERY PARTS OR COMPONENTS IS THE RESPONSIBILITY AND
LIABILITY OF THE MARINE DEALER THAT SUPPLIED THE PUMP OR PARTS AND THE
OPERATOR AND IS NOT COVERED BY THE SEA RECOVERY WARRANTY.
HIGH PRESSURE PUMP WARNING:
section 10 page 61 of 82
Aqua Matic 450-1800 Rev. A