Vddext Power Jumper (P9); Vddmem Power Jumper (P10); Vddflash Power Jumper (P11) - Analog Devices EZ-Board ADSP-BF518F Manual

on and measure voltage across the 0.1 ohm resistor. Once voltage is
P8
measured, power can be calculated. For more information, refer to
Measurements" on page

VDDEXT Power Jumper (P9)

The VDDEXT power jumper (
voltage and current. By default,
two-pin IDC header. To measure power, remove the jumper on
measure voltage across the 0.1 ohm resistor. Once voltage is measured,
power can be calculated. For more information, refer to
ments" on page

VDDMEM Power Jumper (P10)

The VDDMEM power jumper (
rent supplied to the memory interface of the processor. By default,
, and the power flows through the two-pin IDC header. To measure
ON
power, remove the jumper on
resistor. Once voltage is measured, power can be calculated. For more
information, refer to

VDDFLASH Power Jumper (P11)

The VDDFLASH power jumper (
current supplied to the processor core. By default,
flows through the two-pin IDC header. To measure power, remove the
jumper on
P11
voltage is measured, power can be calculated. For more information, refer
to "Power Measurements" on page
ADSP-BF518F EZ-Board Evaluation System Manual
ADSP-BF518F EZ-Board Hardware Reference
1-23.
P9
P9
1-23.
P10
P10
"Power Measurements" on page
and measure voltage across the 0.1 ohm resistor. Once
) is used to measure the processor's I/O
is , and the power flows through the
ON
) is used to measure voltage and cur-
and measure voltage across the 0.1 ohm
) is used to measure flash voltage and
P11
P11
1-23.
"Power
and
P9
"Power Measure-
is
P10
1-23.
is , and the power
ON
2-17