KEB Combivert R6-S Instruction Manual page 42

Monitoring and analysis parameters
No. Name
CP.01 Inverter state
E.Puci "ERROR! Power unit code inv." power unit code is invalid
E.Puch "ERROR! Power unit code changed".
E.PuIn "ERROR! Mains voltage", ripple of rectified mains voltage too high
E.SYn "ERROR! Synchronization", Phase allocation at commutating reactor not correct
E.UP "ERROR! Underpotential", DC link voltage too low
No. Name
CP.02 Actual line frequency
After switching on, the actual mains frequency is determined during the initialization phase.
Slowly changes of the line frequency during the operation are recognized and displayed
in CP.02. CP.02 displays the actual regenerative frequency, if the COMBIVERT R6-S is in
"netof" state.
Resolution
0.01 Hz
No. Name
CP.03 AC current L1
CP.04 AC current L2
CP.05 AC current L3
Resolution
0.1 A
No. Name
CP.06 Act. DC utilization
Resolution
1 %
No. Name
CP.07 peak DC utilization
Resolution
1 %
GB - 42
Meaning
positive values = forward rotating field
negative values = reverse rotating field
Meaning
Display of the actual input current of the respective phase.
Meaning
Independent whether power supply or regenerative operation, the dis-
play indicates the actual utilization of the COMBIVERT R6-S. 100 %
correspond to the rated current of the COMBIVERT R6-S.
Meaning
Parameter CP.07 enables to recognize short-term peak utilization with-
in an operating cycle. For that the highest value of CP.06 is stored in
CP.07. The peak value memory can be cleared by pressing the UP and
DOWN key or via bus by writing any value you like to the address of
CP.07. Switching off COMBIVERT R6-S also clears the memory.
r/w Enter based on
– – ru.00
r/w Enter based on
– – ru.03
r/w Enter based on
– – ru.08
– – ru.09
– – ru.10
r/w Enter based on
– – ru.13
r/w Enter based on
– – ru.14