Validity And Liability; Copyright - KEB Combivert R6-S Instruction Manual

Introduction
• is cost-saving.
The COMBIVERT R6-S is generally protected against overcurrent, ground fault and tempera-
ture. Appropriate dimensioned DC fuses protects the DC link circuit against short-circuit. The
following accessories are necessary for operation with the COMBIVERT R6-S:
• Mains choke / OSF
• EMC filter E6 (for observance of EMC standard)
1.3

Validity and liability

Application and use of our units in the target products is outside of our control and
therefore exclusively in the area of responsibility of the machine manufacturer.
The information contained in the technical documentation, as well as any user-specific advice
in spoken and written and through tests, are made to best of our knowledge and information
about the application. However, they are considered for information only without responsibil-
ity. This also applies to any violation of industrial property rights of a third-party.
Selection of our units in view of their suitability for the intended use must be done generally
by the user.
Inspections and tests can only be done by the machine manufacturer within the framework
of the application. Inspections and tests must be repeated, even if only parts of hardware,
software or the unit adjustment are modified.
Unauthorized opening and improper tampering can lead to bodily injuries or liability insuranc-
es and this cause loss of the warranty. Original spare parts and authorized accessories by the
manufacturer serve as security. The use of other parts excludes liability for the consequences
arising out of.
The suspension of liability is especially valid also for shutdown damages, lost profit, data loss
or other consequential damages. This is also valid, if we have been referred to the possibility
of such damages.
Should any part of this agreement be invalid for any reason, it is to be replaced with a corre-
sponding text, which is valid and equivalent to the intended meaning. The rest of the agree-
ment shall remain unaffected and valid.
1.4

Copyright

The customer may be use the instruction manual as well as further enclosed documents or
parts from it for internal purposes. KEB has the copyrights and they remain effective also
to the full extent.All rights reserved. KEB®, COMBIVERT®, KEB COMBICONTROL® and
COMBIVIS® are registered trademarks of the KEB Automation KG. Other wordmarks or/and
logos are trademarks (TM) or registered trademarks (®) of their respective owners and are
listed in the footnote on the first occurrence. When creating our documents we pay attention
with the utmost care to the rights of third parties. Should we have not marked a trademark or
breach a copyright, please inform us in order to have the possibility of remedy.
GB - 6