Overload (Ol) Function - KEB Combivert R6-S Instruction Manual

Voltage stabilization must be activated at the inverter if a harmonic filter is used.
The units are not short circuit proof without corresponding dimensioned fuses
Exceeding of the max. rechargeable DC link capacity can lead to a defect.
A load draw from the DC circuit may be done only when the message "ready" is set.
If the control release is set when switching off the mains, this can lead to an overcurrent error and the lifetime of
the module can be reduced.
The device must be disconnected from the supply system or the load must be switched off in case of overcurrent or overload.
3.3

Overload (OL) function

Standard:
Release time [s]
270
250
200
150
100
60
105
Table 1:
Modified standard (increased overload):
Release time [s}
300
270
250
200
150
100
50
10
105
110
1. Depending on the line supply impedance
Table 2:
110 120 130
Overload (OL) function
120 130 140
Overload (OL) function
140 150
①
160
150 180 200
Technical Data
Load [%]
160
Load [%]
GB - 17