Removing The Spi Key - Honeywell Galaxy 3-48C Programming Manual

Galaxy 3 Series Programming Manual
2 = Delete File
When selected, the binary file stored on the SPI Key is deleted.
CAUTION: Do not use this command as the SPI key will have to be recalled to Honeywell
2 = Save config
This option allows the panel configuration data to be saved to SPI Key. If selected the user is first prompted
for filename for the saved data. This can be up to 8 characters in length.
Once the filename has been entered the data save sequence is started. The keypad display gives an indication
of the progress until the configuration has been saved.
3 = Check space
If selected this option displays the available space left on the SPI Key. This will display the number of free
memory Kbytes left on the device, out of a maximum of 4096.
4 = Erase key
This option deletes all programming and returns the SPI key to the unformatted state. This option should not
be used.
NOTE: If replacing the software all users, other than the engineer at the keypad in use will be logged out of
the system. The keypad banner will display a warning of what is happening. The engineer will be
given a warning that the panel software is about to be replaced. It will take approximately 2 minutes
to replace the software, during which time the keypads will go off line. Once reprogrammed the
panel will restart.

Removing the SPI Key

CAUTION: Always power down the panel BEFORE removing or connecting the SPI key.
Failure to do so may result in damage to the SPI key. Never "hot-plug" the SPI
key.
1. Remove the SPI Key from the Program Header on the Galaxy 3 Series control panel.
2. Secure the hinged cap to protect the 10-way connector.
Security to be reprogrammed with the software.
71 - SPI Key (cont'd)
177