Honeywell Galaxy 3-48C Programming Manual page 48

45 - Timer Control (cont'd)
On selecting the option, the early opening status of the groups is displayed; early opening enabled is indicated
by a Y below the group; an N is displayed below the groups that are not programmed to open early. All
groups default to N.
NOTE: Only the engineer can enable early opening for individual groups, but global enable must be done
first.
5 = Late Work
The Late Work option — if programmed as 1 = ON — authorizes an Autoset Extension in advance of the
prewarning period (refer to option 65.3 = TIMERS.Autoset);
NOTE: Additional extensions can be authorized by entry of a valid code during the subsequent autoset
prewarning periods.
6 = Weekend Work
The Weekend Work option allows a valid user code to authorize the system to unset at the weekend. If the
Weekend Day is programmed other than 0 = OFF (default), on the next occurrence of the programmed
Weekend Day, the Timers adopt the times they have on the assigned Pattern day. For example, this
allows a Sunday to use the Autoset and Lockout Timers of a Monday.
NOTE: Parameter 41 = Weekend Work must be enabled (default is Disabled) to allow the Pattern Day
option to be programmed by the engineer and the Weekend Day to be selected by the user.
On selecting this option, 1 = Program Days is displayed. Press the ent key; 1 = Weekend Day is dis-
played. Press ent to select this option, or the A or B keys to move between the available options.
1 = Weekend Day
On selecting this option the programmed Weekend Day is displayed; the default is 0 = OFF. Use the A or B
keys to select the required day or days and press the ent key to accept the programming and return to the
previous menu level:
0 = OFF
1 = SAT
2 = SUN
3 = BOTH (Saturday and Sunday)
The selected Weekend Day remains active for one occurrence only. The Weekend Day returns to the
default of OFF immediately following the assigned day. The Weekend Day must be allocated each time the
function is required.
Galaxy 3 Series Programming Manual
42