Honeywell Galaxy 3-48C Programming Manual page 204

Event Log (cont'd)
KEYPAD TEXT
DURESS Duress code has been entered.
ENG ASSEM Engineering Assemble Zone menu (Menu Option 64) has been accessed.
ENG CHECK Engineering Pre-Check menu (Menu Option 66) has been accessed.
ENG DIAG Engineering Diagnostics menu (Menu Option 61) has been accessed.
ENG DIGI Engineering Digicom (Communications) (Menu Option 56) has been accessed.
ENG GROUP Engineering Groups (Menu Option 63) has been accessed.
ENG KPAD Engineering Keypad (Menu Option 58) has been accessed.
ENG LINKS Engineering Links (Menu Option 54) has been accessed.
ENG O/PS Engineering Outputs (Menu Option 53) has been accessed.
ENG PARAM Engineering Parameters (Menu Option 51) has been accessed.
ENG PRINT Engineering Print (Menu Option 57) has been accessed.
ENG QUICK Engineering Quick Menu (Menu Option 59) has been accessed.
ENG SOAK Engineering Soak Test (Menu Option 55) has been accessed
ENG TEST Engineer Test of the system via the Telecom Module.
ENG TMRS Engineering Timers A/B (Menu Option 65) has been accessed.
ENG ZONES Engineering Zones (Menu Option 52) has been accessed.
ENG TAMP Tamper when entering Engineer Mode.
ENGINEER + Entering Engineer mode.
ENGINEER – Leaving Engineer mode.
ENT DELAY User entering Ent Delay State
ENT SET User entering Ent Set State
ENT SETNG User entering Setting State
ENT UNSET User entering Unset State
ENT UNSTG User entering Unsetting State
+ ENTRY Entry zone activated (opened) during Setting/Unsetting procedure or when Set.
– ENTRY Entry zone de-activated (closed) during Setting/Unsetting procedure or when Set.
ETST FAIL Engineer test has failed
ETST PASS Engineer test has passed
+ EXIT Exit zone activated (opened) during the Unsetting procedure or when Set.
– EXIT Exit zone de-activated (closed) during the Unsetting procedure or when Set.
EXITGUARD ExitGuard zone activated (opened).
EXTENSION System or Group(s) are in the Autoset Extension period.
FAIL SET Fail to set event.
FAULT RST Fault has been cleared
FB BATLOW RF Fob has low battery
NOTE: M = Mandatory. NM = Non-Mandatory
NOTE: A plus (+) means an event has started. A negative (-) means an event has finished.
Galaxy 3 Series Programming Manual
DESCRIPTION
D-2
Trigger Event
1. PA/Duress M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
14. Menu Access M
Always TR NM
14. Menu Access M
14. Menu Access M
None NM
Always TR NM
Always TR NM
None NM
None NM
None NM
None NM
None NM
None NM
None NM
None NM
None NM
2. Intruder NM
2. Intruder NM
16. Log NM
10. Setting NM
7. Set Fault M
20. Fault NM
None NM