Option 45 - Timer Control - Honeywell Galaxy 3-48C Programming Manual

45 - Timer Control
Option 45 – Timer Control
1 = View
This option allows the programmed times in each of the Timers to be viewed:
1. Timer A;
2. Timer B;
3. Autoset
Use the A and B keys to scroll through each of the programmed times.
NOTE: The programmed times cannot be modified using this option.
All of the programmed timers - Timer A, Timer B, Autoset - can be printed out using option 57.11 =
SYSTEM PRINT.Timers.
2 = Holidays
This function allows up to ten holiday periods to be allocated. A Start and End date is entered for each
holiday period using the 1 = Modify Dates option, and the groups that are affected by the programmed
holiday periods are assigned using the 2 = Assign Groups function. The operation of all timers for the as-
signed groups is suspended during these dates; the last operation of the Timers before the start date remains
in operation until the first operation after the end date. For example, a code which has been allocated the
Timer A period in the CODES option (42.1.4.1) will be inoperative during the programmed holiday period if
the Timer A is in the On time when the holidays starts.
1 = Modify Dates
On selecting this option, the Start and End dates for holiday period 1 are displayed; an arrow (>) points to
the Start date. If no dates have been entered for this period, then the display shows
the Start date, press the ent key; the date display changes to >DD/MM<; enter a valid four digit number
and press the ent key to accept the selection; the year is not required, only the day and months (dd/mm).
Press the # key to move to the end date and follow the procedure for programming the Start date. The #
key toggles between the Start and End dates for each holiday; the arrow (>) indicates which date is currently
selected.
To remove a programmed date, press the
Use the A or B key to move between the different holiday periods or enter the number of the holiday period
(1 – 10) to be programmed.
The holiday periods can only be programmed by the master manager and engineer. Users can access this
option, however, they can only view the programmed holiday dates.
Galaxy 3 Series Programming Manual
key. The date display returns to
40
/ . To program
/ .