Table of Contents
Advertisement
Adding or Replacing the Computer or Devices
E-9
Solutions:
Check the following.
❏ Devices are turned on.
❏ You can access the Internet and other computers or network devices on the same network from the devices you
want to connect to the printer.
If still does not connect your printer and network devices after confirming the above, turn off the wireless router.
Wait for about 10 seconds, and then turn it on. Then reset your network settings by downloading and running the
installer from the following website.
http://epson.sn
> Setup
Related Information
"Making Settings for Connecting to the Computer" on page 289
&
E-10
Solutions:
Check the following.
❏ Other devices on the network are turned on.
❏ Network addresses (IP address, subnet mask, and default gateway) are correct if you have set the printer's
Obtain IP Address to Manual.
Reset the network address if they are incorrect. You can check the IP address, subnet mask, and default gateway
from the Network Status part on the network connection report.
Related Information
"Network Settings" on page 358
&
E-11
Solutions:
Check the following.
❏ The default gateway address is correct if you set the printer's TCP/IP Setup setting to Manual.
❏ The device that is set as the default gateway is turned on.
Set the correct default gateway address. You can check the default gateway address from the Network Status part
on the network connection report.
Related Information
"Network Settings" on page 358
&
>
Checking the Network Connection Status
309
>
...
Printi
Advertisement
Table of Contents
