Vatech Green 21 PCT-90LH User Manual page 7

Green21 (Model: PCT-90LH) Installation Manual
1. Failure to read and understand the information provided in
this manual may result in physical injury, damage to the
equipment or equipment failure. Make sure to read each
chapter in its entirety and understand the information therein
before attempting any of the installation procedures.
2. The installer must confirm that the system is installed
according to the instructions provided by this manual and
perform the appropriate procedures therein.
3. If the equipment has been stored at temperatures of below
10℃ (50℉) for more than a couple of hours, allow the
equipment to reach room temperature before applying
mains voltage.
4. Installation and related work must only be performed by
people authorized by VATECH.
5. Do not connect any items or equipment to this system
which are not part of the system: IEC60601-1-1 (3rd edition:
2005).
6. Any equipment not approved by VATECH must comply with
the applicable standards: IEC 60950-1 (2nd edition: 2005)
for IT equipment (Ex: PC) and IEC 60601-1 (3rd edition:
2005) for medical electrical equipment.
7. All operators of this equipment are responsible for ensuring
that the
requirements outlined in IEC 60601-1-1 (3rd edition: 2005):
Safety
Requirements for Medical Electrical Equipment are fully met
to ensure the safety of patients, operators, and the
environment.
8. Never touch sensitive areas such as sensors during
installation. These areas are indicated at the applicable
stages during the installation procedures.
9. Using wireless phones may interfere with the operation of
this equipment.
10. Use an ESD (electrostatic sensitive device) wristband
during installation and connect it to a ground wire.
11. Touch a ground point to discharge static electricity before
handling PCB boards.
Important Precautions
v