Table of Contents
Advertisement
5 - Operation
Maneuvering of the boom - TERRA FORCE
±
WARNING! The pendulum lock automatically turns ON when pressing one of the folding buttons. Boom folding is not
possible if the pendulum is unlocked. A manual override of the pendulum lock is possible by activating switches 2 or 3
on the SetBox or switch 4 on the self-propelled instrument panel.
±
WARNING! Only operate the folding functions when the sprayer is stationary! Failure to do so may damage the boom.
The pendulum lock automatically opens at speeds exceeding 0.9 mph (1.5 km/h)!
ATTENTION! If a folding sequence is not completed, a warning message on the Hardi display will ask you to complete
this sequence before starting next sequence.
ATTENTION! Only buttons relevant for boom functions are mentioned here.
To unfold the boom using the SetBox & Grip controls (Trailed models)
1. Press the boom lift button (H) to lift the boom clear of the transport
brackets.
2. Press and hold (A) and (C) to tilt boom wings up.
3. Press and hold button (5) to unfold the inner sections completely
(approximately 5 sec. or a warning will appear). Check that the
pendulum locked symbol
4. Press and hold (B) and (D) to tilt boom wings down.
5. Press and hold button (7) to unfold the 1st outer sections.
6. Press and hold button (9) to unfold the 2nd outer sections (120'-
132' tri-fold booms only).
7. Press and hold the boom down button (I) to lower the boom to the correct working height.
8. If not unlocked, then press (2) and
10 seconds.
±
WARNING! The pendulum lock automatically opens when you begin to drive. Drive slowly until the pendulum is
completely unlocked. The boom must be unlocked before engaging AutoTerrain system.
To fold the boom using the SetBox & Grip controls (Trailed models)
1. Press and hold button (18) to set neutral slant angle (no slant).
2. Press the boom lift button (H) to raise the boom to the highest
possible position.
3. Press and hold button (8) to fold the 2nd outer sections (120'-132'
tri-fold booms only). The
pendulum is locked. This takes approximately 10 seconds.
4. Press and hold button (6) to fold the 1st outer sections. Check that
the pendulum lock symbol
5. Press and hold (A) and (C) to tilt boom wings up.
6. Press and hold button (4) to fold the inner sections.
7. Press the boom down button (I) to lower the boom until it rests in
the transport locks.
8. Press and hold (B) and (D) to tilt boom wings down into the
transport rests.
5.2
is visible in the display.
symbol appears in display until pendulum is unlocked. This takes approximately
symbol appears in display until
is visible in the display.
A
B
E
I
H
C
D
F
G
Advertisement
Table of Contents
