Fronius TransTig 800 Operating Instructions Manual page 51

Fit ferrules to phase conductors and the ground conductor of the mains
3
cable; crimp ferrules with pliers
CAUTION!
Risk of short circuits!
If ferrules are not used, there is a risk of short circuits between the phase
conductors or between phase conductors and the ground conductor.
▶
Fit ferrules to all phase conductors and the ground conductor of the
stripped mains cable.
7
5
Undo the screws (2 x) and clamping
4
nut (size 30) on the strain-relief
device
Insert the mains cable into the
5
strain-relief device
NOTE!
Push the mains cable in far enough to
make it possible to connect the
P E
ground conductor and the phase con-
W 1
V 1
ductors to the block terminal prop-
U 1
8
erly.
Tighten the clamping nut (size 30
6
mm)
Tighten the screws (2 x)
7
Connect the mains cable to the
8
block terminal correctly:
- Ground conductor (green, or
green with yellow stripes) to
the PE connection
- Phase conductors to connec-
tions L1 - L3
Re-fit the left side panel of the
9
power source
51