Controller Setup - Omron Sysmac F430-F Series Connection Manual

7.3. Controller Setup

Set up the Controller.
7.3.1. Hardware Settings
Set the switches on the Serial Communications Unit.
Precautions for Correct Use
These hardware settings must be done with the power OFF.
1
Confirm that the power to the
controller is OFF.
* If the power is ON, you may
not be able to proceed in
subsequent
according to the described
procedures.
Confirm the position of the
physical switches on the front of
the Serial Communications Unit
according to the figure on the
right.
Check the position of the "Port
2" (RS-232C)
referring to the figure on the
right.
* Assumes the use of "Port 2" on
the Serial
Unit.
2
Set the Unit. No. switch to [0].
(The factory default unit number
is "0")
3
Connect
Communication
controller as shown on the right.
Connect the Smart Camera
cable to
Communication Unit.
Connect the controller to the PC
by USB cable.
operations
connector,
Communication
the Serial
Unit to the
the Serial
PC
Controller
USB cable
Power Supply Unit
Serial Communication
Unit
End Cover
Smart
camera
Special cable
20