Overview - Omron Sysmac F430-F Series Connection Manual

4. Overview

This document describes the procedures for connecting the Omron smart camera (F430-F
Series) to the NJ Series Machine Automation Controller (hereinafter referred to as Controller)
via serial communications and for verifying the serial connection.
Refer to Section 6. EtherNet/IP Settings and Section 7. EtherNet/IP Connection Procedure to
understand setting methods and key points for setting up Serial Communications.
Using the user program in the "CX-Programmer Project File" and the protocol data in the
"CX-Protocol Project File" prepared in advance, use the "Measurement trigger" command for
the smart camera to check the serial communication connection.
Obtain the Sysmac Studio project file in advance before proceeding. Contact Omron for
information on how to obtain this file.
Name
Sysmac Studio Project File
(Extension: smc2)
CX-Protocol
(extension: psw)
The purpose of this document is to explain the wiring method, the
communication settings required for connection of the devices and the step by
step setting procedure. The program included with the document was created
using the same procedures and can be used to confirm that all the settings have
been made correctly and that a connection can be established (Confirm
Connection). It is not a program created on the premise of constant use in the
field, so its functionality and performance aspects have not been fully
considered. When building an actual system, it is necessary to refer to the wiring
method and communication setting contents and setting procedures described
in this document, and to design a new program according to the customer's
purpose for the program.
This example shows a general precaution for
something that you must do.
OMRON_F430_NJ_PMCR232C_V100.smc2 Ver.1.00
Project File OMRON_F430_NJ_PMCR232C_V100.psw
Filename Version
Ver.1.00
4