Serial Communication Settings; Configuring The Serial Communication Settings - Omron Sysmac F430-F Series Connection Manual

6. Serial Communication Settings

An explanation of the communication parameter specifications and cable wiring.
Note
If you wish to use communication settings other than those described in this chapter, you
must also change the program used. For more information on the program, please refer to "9.
Program".

6.1. Configuring the Serial Communication Settings

The Following are the Serial Communication Settings.
Parameter (Setting)
Unit Number
Connection Port
Serial Communication Mode
Data Bits
Stop Bits
Parity
Baud Rate
Protocol macro transmission
method
Header
Footer
Precautions for Correct Use
It is assumed that the serial communication unit used is "CJ1W-SCU22", the unit number is
"0", the communication (connection) port is "port 2" and these have been set ahead of
time.When connecting under conditions other than this, refer to Section 9 "Program" and
change the control data of the assigned Relay Area and PMCR Instruction to create a
program.
SCU Unit *
0
Port 2 (RS-232C)
Protocol Macro
8 bit
1 bit
No
115,200bps
Full Duplex
-
-
* SCU Unit: Serial Communications Unit
Smart camera
-
-
-
8 bit (default)
1 bit (default)
None (Default)
115,200Bps (default)
-
None (default)
<CR+LF>
8