Camera Setting By The Osd; The Camera Setting Change By The On Screen Display; The Camera Setting Change By The Controller That Connects To Cn1; Osd Operation By The Communication Software - Omron STC-S133 Series Manual

7

Camera setting by the OSD

This camera can change the camera settings by the On Screen Display function.
7.1

The camera setting change by the on screen display

The camera setting change by the controller that connects to CN1

A. It is necessary to enable the OSD switch function by the communication software before use the controller.
(The OSD switch function is enabled for the Default: setting)
Please check the 4-6. OSD tab descriptions.
B. Controller connector on the camera (on rear side of the camera)
Please check the OSD section.
C. Controller circuit
CN1 pin assign
1) UP
2) ENTER
3) LEFT
4) RIGHT
5) DOWN
6) GND
D. Switch button function
Below function is assigned for each button.
ENTER
UP
DOWN
LEFT
RIGHT

OSD operation by the communication software

A. It is necessary to disable the OSD switch function by the communication software before use it
Please check the 4-6. OSD tab descriptions for details of the operation.
STC-S133 Series
Specifications
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
Display OSD menu, select setting
Select up (menu selection)
Select down (menu selection)
Select left (setting selection)
Select right (setting selection)
No.16S061-09
44/55