Relay Unit (for Option 06)
AWG7000 Series Service Manual
3. Use a 5/16 inch torque wrench to remove the six SMA cables (or 12 SMA
cables for 2 channel models) from the relay units.
4. Disconnect the cable (or two cables for 2 channel models) from the relay units.
5. Remove the 10 screws securing the relay unit to the chassis.
6. Lift the relay unit away from the chassis.
Installation. To install, reverse this procedure. See Figure 4-15 for cable
connections.
To J1000 on the CH2 OUT10G board
For the AWG7052 Option 02
Front
To J1000 on the CH1 OUT10G board
Figure 4-15: Relay unit cable connection for option 02
You need a screwdriver with a T-15 Torx tip and a 5/16 inch torque wrench (items
1, 2, and 9).
Removal and Installation Procedures
To J1012 on the CH2 OUT10G board
To J101B on the AWG10G board
To the Channel2 Analog connector
To J1010 on the CH2 OUT10G board
To J111B on the AWG10G board
To the Channel2 Analog connector
To the Channel1 Analog connector
To J101A on the AWG10G board
To J1012 on the CH1 OUT10G board
To the Channel1 Analog connector
To J111A on the AWG10G board
To J1010 on the CH1 OUT10G board
4-31