Tektronix AWG7000 Series Service Manual page 107

Table 4-8: Hardware error (cont.)
Error code Error log message
300000217 An attempt was made to load a program with an incorrect
format.(PLD130b.Bit)
300000218 The DCM timeout period has expired.
300000219 The LOCKED timeout period has expired.
300000220 A PLD131.bit file is old version.
300000221 A PLD130.bit file is old version.
310000000 The parameter is incorrect.
390000001 The calibration data is invalid. The default value is used.
390000002 *** Warning *** It started with Manufacturing mode.
390000003 The calibration data is invalid. The default value is used.
After Repair
AWG7000 Series Service Manual
After removal and replacement of a module, you must perform the Adjustment and
Performance Verification procedures. You can find the information about these
procedures in the following manuals:
AWG7000 Series Arbitrary Waveform Generators Service Manual (Tektronix
part number 071-1854-XX)
AWG7000 Series Arbitrary Waveform Generators Specifications and
Performance Verification (Tektronix part number 071-1853-XX)
Possible defect Note
on board
N/A
MIO MIO: U300
MIO MIO: U300
N/A
N/A
N/A
N/A
N/A
N/A
Troubleshooting
4-55