Procedures for External Modules
Handle Unit
Snaps
AWG7000 Series Service Manual
You need a screwdriver with a T-20 Torx tip (items 1 and 4).
Removal. To remove the handle unit, refer to Figure 4-4 on page 4-12 and follow
these steps:
1. Remove the two screws securing the handle base bracket to the cosmetic cover.
2. Grasp the bracket and handle away from the cosmetic cover.
Installation. To install, reverse this procedure.
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal. To remove the snaps, refer to Figure 4-4 on page 4-12 and follow these
steps:
1. Remove the four screws securing the snaps to the cosmetic cover.
2. Lift the snaps away from the cosmetic cover.
Installation. To install, reverse this procedure.
Removal and Installation Procedures
4-11