Tektronix AWG7000 Series Service Manual page 59

Removal and Installation Procedures
Preparation
Adjustment after repair
List of Modules
AWG7000 Series Service Manual
This section contains procedures for removal and installation of all mechanical and
electrical modules.
Only qualified personnel should perform service procedures.
WARNING.
Before performing this or any other procedure in this manual, read the General
Safety Summary and Service Safety Summary found at the beginning of this
manual.
To prevent damage to the instrument components, read Preventing ESD in this
section.
Before doing any procedure in this section, disconnect the power cord from the line
voltage source.
This section contains the following items:
This preparatory information that you need to properly do the following
procedures.
List of tools required to remove and disassemble all modules.
Procedures for removal and reinstallation of the modules.
Read Equipment Required for a list of the tools needed to remove and install
NOTE.
modules in this instrument. See Table 4-3, on page 4-10. Read the cleaning
procedure before disassembling the instrument for cleaning.
After the removal and replacement of a module due to electrical failure, perform
the adjustment procedures. Refer to the Adjustment Procedures section.
The Replaceable Parts section provides a list of all replaceable modules. Any
electrical or mechanical module, assembly, or part listed in the parts list is referred
to as a module.
4-7