Remove an SFP module
Steps
1. If a cable is connected to the SFP, disconnect the cable.
2. Gently pull down on the spring release latch.
3. While still holding onto the latch, gently pull out the SFP module.
CAUTION:
Do not remove the I/O module. Removing the I/O module causes the node to reboot immediately.
Example
Figure 60. Removing an SFP module
Install an SFP module
Steps
1. Verify that the replacement SFP module has the same part number as the failed SFP module.
The part number is on a label attached to the SFP module.
2. Push the spring release latch up and slide the new SFP module into the port until it is securely connected.
Figure 61. Installing an SFP module
3. Push the spring release down to lock the SFP module into place.
4. Reconnect the cable to the replacement SFP module.
Example
Verify the operation of a replacement SFP module
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the SFP module.
3. On the Components card, under Rear View, expand BaseEnclosure.
4. Expand the node that includes the SFP module, and select the SFP module under either 4PortCard or IOModule.
58
Base enclosure service procedures
EMC3551
EMC3550