Remove The Embedded Module Cover From The Node - Dell EMC PowerStore 500T Installation And Service Manual

Figure 50. Disengaging the locking mechanism for node B
5. Before removing the node, ensure that the wire bail is properly secured to the power supply cable of the other node to
prevent accidental loss of power and cache.
6. Use the release handle to pull the node outward enough to grasp the sides with both hands. Then, with both hands
supporting the node, pull the node fully out of the enclosure.
Figure 51. Removing the node
7. Place the node on a clean, flat, static-free work surface.

Remove the embedded module cover from the node

Steps
1. While pushing down the blue release buttons, slide the top cover towards the rear of the system until it stops.
2. Lift the top cover upward, and remove it from the node.
52 Base enclosure service procedures