Install A Dc Power Supply - Dell EMC PowerStore 500T Installation And Service Manual

Steps
1. Remove the power cable from the power supply.
Figure 44. Removing a DC power cable
2. Push and hold the orange release tab to the left (to the right for the upside-down power supply) and grasp the power supply
by its handle. Remove the power supply by pulling it from the node.
Figure 45. Removing a DC power supply

Install a DC power supply

About this task
The power supplies are installed in the top and bottom nodes, meaning that the top power supply is installed upside-down. This
procedure works for installing either power supply.
Steps
1. Align the power supply with the slot in the node.
2. Push the power supply into the node until it clicks into place.
Base enclosure service procedures 47