Remove The Top Cover From The Node; Remove The Internal M.2 Boot Module - Dell EMC PowerStore 500T Installation And Service Manual

Figure 89. Removing the node
7. Place the node on a clean, flat, static-free work surface.

Remove the top cover from the node

Steps
1. While pushing down the two blue release buttons, slide the top cover towards the rear of the system, until it stops.
2. Lift the top cover upward, and remove it from the node.
Figure 90. Removing the top cover

Remove the internal M.2 boot module

Steps
1. Gently pull straight up on the blue pull tab to release the internal M.2 boot module from the motherboard.
78 Base enclosure service procedures