Table of Contents
Advertisement
Operation of driving loader
1.
Operate the manipulating handle and transfer the bucket
backwards to the limit position; then raise the arm to the
transportation position, i.e., the distance from the hinged
point below the arm to the ground is about 500mm.
2.
Depress service brake pedal and meanwhile pull down the
parking brake handle to release the parking braking. Slow-
ly release service brake pedal and observe whether the
equipment is moving.
If the machine moves on the flat ground, please immediately
depress brake pedal and pull up the parking brake pedal
handle to apply the braking. Check the shifting control system
of this machine for the faults. If it is on the slope, please first
use the wedge to stop the wheel to prevent the vehicle from
moving, then check the machine again.
3.
Push the shifting handle forwards to Gear Forward 1st
,push the shifting handle backwards to engage Gear Re-
verse and meanwhile depress the throttle pedal.then tehe
manchine can go forward or retreat.
4.
Drive the machine to the flat ground. If the steering inspec-
tion is not performed due to narrow space during the op-
eration in previous stage, now it is necessary to rotate the
steering wheel. Check whether the machine can make a
turning leftwards or rightwards.
3-8 Operation
WARNING
Advertisement
Table of Contents
