Table of Contents
Advertisement
If the machine needs to be stored for
a long time, operate according to the
following requirements:
A.
Before storage
Wash each part of the vehicle, dry and store in a dry
●
warehouse. If the machine is only allowed to be stored in
the open, it is necessary to park the machine on the con-
crete road surface where the drain is easy, and use the
canvas to cover.
Before storage, the fuel tank must be filled with fuel, and
●
fill lubrication grease to each movable axis pin, propeller
shaft, and replace hydraulic oil.
Put the shifting manipulating handle on "Neutral Gear"
●
position, and put the shifting manipulating Neutral Gear
locking plate on "Locking" position.
Pull up the handle of parking brake to apply parking
●
braking.
Put the bucket on a flat ground, and toggle the working
●
device handle to the middle position.
Toggle each switch to middle position or "OFF", and lock
●
all doors.
Coat a thin layer of grease on the open part of the piston
●
rod of the hydraulic cylinder.
Remove battery from the vehicle, and store it separately.
●
Air temperature decreases to below 0 , add anti-freeze
●
fluid into cooling water for engine, and make anti-freeze
fluid able to access engine body and A\C system radia-
tor. Or you can drain out the water in the cooling system.
Pay attention that you should also drain out the water in
the radiator of A\C system.
After the machine is fixed, use frame-fixed bumper to fix
●
the front and rear frames.
3-12 Operation
Advertisement
Table of Contents
