Table of Contents
Advertisement
Prohibit lifting the bucket to a higher position to conduct the
transportation operation; otherwise it will cause the tip-over
of the machine.
Dumping
●
① Dumping the materials to truck or hopper
When the loader with full materials is 15m away from the
truck or hopper, you should release throttle pedal. You
can use service braking to conduct "snub" if necessary,
to reduce the machine speed to slowly approach the
truck or hopper. Meanwhile, the driver shall toggle the
arm manipulating handle backwards to the limit position.
At this time, the driver can release hand and the handle
will not return back to the middle position under the
force of magnet. During this process, the driver shall
be careful for driving the machine and closely watching
the approaching of the bucket to the truck or hopper,
not causing the collision of the bucket and the truck or
hopper.
When the bucket is located right above the truck or
hopper, the driver shall depress the brake pedal to make
the machine stop. Then, push the bucket manipulating
handle forward to make the bucket tip-over forward to
dump the materials into the truck or hopper. Here, the
driver shall closely watch the movement of the bucket,
not causing the collision of the bucket and the truck or
hopper edge. If the material is stickier, it is necessary to
repeatedly push the bucket manipulating handle back
and fro, to make the bucket limit stop repeatedly impact
the arm, making the materials attached onto the bucket
fall off.
If the length of the vehicle body is two times as width of
the bucket, the unloading operation shall begin from the
front portion of the vehicle body.
WARNING
Operation 3-17
Advertisement
Table of Contents
