Table of Contents
Advertisement
B. Under the high temperature and wet weather, all parts
of the machine will be corroded, and they will be more
easily corroded in rainy season. The metal surface will
be rusted and paint blistered, and other surfaces will
have speckles.
C. Coat the anti-corrosive lubrication oil onto unpainted
or naked surface. Use insulation mixture to protective
wires and terminals. Use paint or proper anti-rust ma-
terials on the damaged surfaces to prevent from being
rusted or corroded.
Operation in the dusty or sandy area
Dust will be produced in most places during operating ma-
chines. However, you must adopt the preventive measures in
severely dusty or sandy places.
1.
Keep the cooling system and cooling area clean. You can
use compressed air to purge them for cleaning, and shall
adopt this measure as much as possible.
Wear protective goggles when using compressed air.
2.
When maintaining the fuel system, you must be careful to
prevent dust and sand from entering the oil way.
3.
Frequently maintain air filter, check air control indicator
everyday, and keep dust cover and dust screen clean. Pre-
vent dust and sand from entering engine parts and compo-
nents as much as possible.
4.
Perform lubrication and maintenance according to the
lubrication diagram attached on the machine and to the
instructions in Section 4 of "maintenance Period Chart".
Clean all lubrication oil connectors. The mixing of sand and
lubrication oil will cause the wear and expedite the wear of
parts.
5.
Keep the equipment clean as much as possible. Put the
loader under the shed to prevent the machine from being
impaired by sand or dust.
WARNING
Operation 3-25
Advertisement
Table of Contents
