INSTRUMENT PANEL
1. Timepiece
It is used to indicate the working time of the machine, in
hours. The working scope of the timepiece is: 0 - 9999.99
hours. When the engine is started, the timing begins
2. Horn switch
There are two horn switches in this machine: "A" at the
center of steering wheel and "B" at the end of combo han-
dle; the functions of both switches are the same. Switching
on any horn switch of them will blare
There are three horn switches equipped for the single pilot
handle in this machine. "C" on left side of the single pilot
lever; the functions of these three switches are the same.
The driver can decide to use which switch based on his
operation customs.
2-30 Operation Controls
Figure 61
Figure 62