Table of Contents
Advertisement
The steering wheel cannot restore to original position
after rotation, and the machine rotation angle is kept un-
changed. Therefore, after the machine finishes the steer-
ing, you should reversely rotate the steering wheel to
eliminate the relative angle between front and rear frames
of the machine and make the machine drive along the
straight direction. After completion of the steering opera-
tion, you should toggle the steering lamp to the middle po-
sition, and the steering lamp and the steering indicator will
go off immediately.
When performing the steering at higher speed, you must
release the throttle pedal and, if necessary, use service
braking to decrease the machine speed and then conduct
the steering operation so as to ensure the driving safety.
Strictly prohibit conduct the steering operation on the slope.
You should drive the machine down to the flat ground to
perform these operations.
8.
Braking operation of machine
When the braking is needed for the machine, it is neces-
sary to first release the throttle pedal and then smoothly
depresses the service brake pedal. At this time, the brak-
ing can be applied.
When the machine is driving at high speed, you cannot
abruptly depress the throttle pedal to the bottom to prevent
from the safety accidents or machine damage due to braking
too suddenly unless in the emergency.
3-10 Operation
WARNING
WARNING
Advertisement
Table of Contents
