Table of Contents
Advertisement
1. Loading and unloading machine is dangerous. Be
especially careful for running engine at low speed and
driving at low speed.
2. The inclined plate must withstand the weight of the
machine. If necessary, you can add the cushion block to
increase the support force.
3. Ensure there is no grease, mud etc on the inclined plate
to prevent the slippery of the machine.
4. When you load or unload the machine, the trailer shall
park on the solid flat ground.
5. When the machine is running on the trailer, you must
keep the lowest engine speed and drives at the lowest
speed.
6. Fix securely the machine onto the trailer according to
the local laws and regulations.
During shipping, please follow the laws and regulations about
the shipment height, width, length and weight issued by State
and local authorities.
Perform the shipping according to the procedures shown below:
1.
Use wedges to stop the wheels of trailer or truck before
shipping.
2.
Do not allow the steering operation on the way for the ma-
chine being driven on to the trailer or the truck. You should
back the vehicle to the flat ground, and then perform the
steering operation
3.
After the machine is fixed, use frame-fixed bumper to fix
the front and rear frames.
4.
Lay the bucket down to the transportation vehicle, put the
shifting manipulating handle on "Neutral Gear" position,
and put the neutral gear locking plate on "Locking" posi-
tion.
5.
Pull up the button of parking brake to apply parking brak-
ing.
6.
The engine is switched off, and all switches are put to Mid-
dle position or "OFF position. Pull out the electric lock key.
7.
Close and lock all doors, then take away the buttons.
8.
Toggle the power supply Negative switch to "OFF" posi-
tion.
9.
When you use truck or trailer to transport the machine, you
must use wedges to stop the wheels and use steel cables
to fix the machine, so as to prevent the machine from mov-
ing during transportation.
5-2 Transportation
WARNING
Fig 1
Fig 2
Fig 3
Advertisement
Table of Contents
