Checking Brake Lining Wear - PRONAR T672ECO User Manual

Periodic inspections of the trailer
5.10

CHECKING BRAKE LINING WEAR

• Find the inspection hole.
Depending on the version of the
road axle, the inspection hole
may be located in a different
place than the figure shows, but
it will always be located on the
brake shield.
• Remove the upper and lower plugs
and then check the thickness of the
lining.
• The brake shoes should be replaced
if the thickness of the brake lining is
less than 5 mm.
• Check the remaining linings for wear.
Figure 5.8 Checking
thickness
(1) blanking plug (2) brake lining
PRONAR T672ECO
Chapter 5
1
Gmin 5mm
2
526-I.09-1
the brake lining
I.3.4.622.11.1.EN
5.13