PRONAR T672ECO User Manual page 92

Chapter 4
DANGER
When opening wall closures and locks, be extremely
cautious due to pressing the load on the walls.
When closing walls and the chute window slide, be
extremely careful to avoid crushing your fingers.
of the load into the packaging (bags,
boxes, etc.). The size of the gap opening
should be determined by the lever (3). To
do this, loosen the bolt locking the slide
(4), open the slide at the selected height
and secure it again with the screw.
During unloading, using the chute, the wall
locks and extensions must not be opened,
and the load box must be lifted slowly
and smoothly. Rapid lifting of the load box
will cause very high pressure on the rear
part of the load box as a result of the load
shifting and may threaten the stability of
the machine.
PRONAR T672ECO
4.22
CAUTION
Unloading of the trailer can only be carried out when
the machine is placed on level, hard and level sur-
face and connected to the tractor. Tractor and trailer
must be placed for straight-ahead driving.
Use only original tipping pins. The use of non-original
pins may damage the trailer. Tipping pins must be
properly locked.
The length of the cable controlling the valve limiting
the angle of inclination of the load box is set by the
Manufacturer and it is forbidden to adjust it by the
User.
It is forbidden to pull the trailer forward if the bulk or
scattering load has not been unloaded.
Unloading of volumetric materials that have been
loaded above 1 meter can only be done by tilting the
load box backwards.
Make sure that during unloading nobody is near the
tilted load box and the falling load.
Tilting of the load box may be performed only when
the trailer is connected to the tractor.
It is forbidden to tilt the load box during strong gusts
of wind.
It is forbidden to start or drive with the load box
raised.
If the trailer is equipped with central extensions,
unloading can only be done by tipping the load box
backwards.
Rules of use
H.3.3.259.08.1.EN