Table of Contents
Advertisement
Chapter 6
6.5 ELECTRICAL
ELEMENTS
CAUTION
Driving with defective lighting installations is prohibit-
ed. Damaged lamps should be replaced immediately
before driving off. Lost or damaged reflectors should
be replaced with new ones.
Before travelling, make sure that all lamps and re-
flectors are clean.
Electrical installation service is reduced to
periodic inspection of the control system
and lighting system.
Work related to the repair, replacement
or regeneration of electrical installation
components should be entrusted to spe-
cialized workshops that have appropriate
technologies and qualifications to perform
this type of work.
The user's duties include only technical
inspection of the electrical installation and
reflectors.
THE SCOPE OF ACTIVITIES
• After aggregating the trailer with the
tractor, connect the power supply
cable for the lighting installation.
Make sure the connection cable
is OK. Check the connection
sockets on the tractor and on
the trailer. If necessary, clean all
dirt and dust.
• Check the completeness, technical
PRONAR T672ECO
6.10
SYSTEM
SERVICE AND
condition and correct functioning of
the trailer lighting.
Check the wiring harness for
damage
(rubbed
wire break, etc.). Check the
completeness of lamps and all
reflectors.
In the event of a burn, the bulb
must be replaced immediately.
The trailer bulbs are presented
in table (6.1). All lamp shades of
lighting lamps are mounted with
screws and there is no need to
disassemble the entire lamp or
trailer components.
• Check the correct installation of
the triangular plate holder for slow
moving vehicles.
• Before travelling on a public road,
make sure that the tractor has a re-
flective warning triangle.
Technical Support
WARNING
insulation,
Advertisement
Table of Contents
